Customer Reviews for VEVOR Manual Wire Stripping Machine, 0.06''-0.98'' Copper Stripper with Hand Crank or Drill Powered, Visible Stripping Depth Reference, Portable Aluminum Frame Wire Peeler for Scrap Copper Recycling

Good value for the money. Easy to use, good for the beginner or the expert. Would buy again.

I use this machine for wire stripper. It work awesome.

Great tool..My son seems to be quite happy with it..Thank you

Easy to use great value for the money easily paid for itself on first use.

Does the job stripped a whole 55gal trash can full of wire in a couple hours

Just like a bunch of other people have said, it takes a little bit to figure out how low to adjust the blade and get it dialed in, but once I figured it out it's been amazing for stripping a bunch of different sizes of copper wire. Helpful tip, it probably needs to be lower than you think it does, it will not break the blade or anything. Also, another Trek I have found is to put the wire in a hole that is lower and then it pushes it up into the blade. Only problem I have found is that it needs a shield on the side of the inside of the motor. wire sometimes curves right into it and gets stuck if you're not holding the other end, but it's an easy fix, just wrap a piece of aluminum around it or put an eyelet in front to run the wire through.

Makes me life so much easier to peel wire

My husband loves it. This works great for striping wires

A couple of things I kind of figured out. First the bigger the wire, you will have to help either push or pull it through the hole. I don't think the teeth that grip the wire are big enough for the big stuff, haven't tried smaller wire yet. It also helps to cut the wire into 3 to 4 feet pieces.

Product works well. I welded an Allen key to the shaft. Works great. A strong drill is needed. Cordless drill won_ work. If possible use a drill that has adjustable speed.